Portable Burn Pan

PBEM's portable burn pan is a fire extinguisher demonstration tool intended primarily for community engagement events. However, it can also serve as a NET training tool for low-intensity training when the usual burn pan at Portland Fire & Rescue Training is not available. NET volunteers trained on its setup and use can check out the burn pan.

Load video

YouTube

YouTube might collect personal data. Privacy Policy

ContinueDismiss

Video: A comically dramatic preview of how the ITS works.

Safety Considerations

Safety rules for scheduling burn pan check-out

• PBEM will not check out the burn pan for use on days when the heat index is at or above 90°F. Not only is it unsafe for trainees to stand around in direct the sun for a prolonged period, but heat can cause the contents of a propane tank to expand and possibly cause a leak. If the borrower has a plan to mitigate these factors, PBEM can reconsider.
• A minimum of two volunteers trained on the burn pan is required to check it out for a session. One volunteer needs to operate the control pad, while the other needs to ensure trainees are engaging in safe practices and keeping an eye out for prospective hazards.

Propane tank safety

Load video

YouTube

YouTube might collect personal data. Privacy Policy

ContinueDismiss

Video: Propane tank safety.

1. 

   The insides of a propane tank.
   NEVER store or place a propane tank indoors or in an enclosed area such as a basement, garage, shed, or tent. It is illegal and highly unsafe to store propane tanks indoors.
2. When transporting a propane tank in a vehicle:
   • ALWAYS make sure your vehicle is vented (e.g. open a window).
   • Do not place a propane tank in a hot, confined space (such as a trunk on a hot day).
   • Make sure the propane tank is secure, preferably by placing it down and behind a seat. Think about where a 40 lb. propane tank is going to go if your vehicle were in a collision.
3. NEVER try to modify or repair valves, regulators, or other tank parts.

Instructing with the Burn Pan

Load video

YouTube

YouTube might collect personal data. Privacy Policy

ContinueDismiss

Video: It's important that people understand why you never use water on a grease fire.

The instructor MUST be familiar with, and able to instruct without deviating from, the CERT guidelines for CERT fire extinguisher use (click HERE to review). Optimally, trainees will also be familiar with this material.

Here are helpful videos to illustrate home fire dangers:

• What happens if you pour water into hot oil?: Good showing on why you never use water to put out a stovetop fire (use baking soda instead).
• Flashover Demonstration: The Oak Ridge Fire Department shows you how fast a fire can grow.
• NIST Scotch Pine Demonstration: Probably the most dramatic video; often shown in NET Basic.
• Room Flashover: Demonstrates how quick fire can destroy a single room.

Burn Pan Set-up and Use

Burn pan ingredients

You will need:

• 1.) The burn pan base unit, which comes in a large plastic roll case. It requires two people to lift it safely (if it needs to be lifted for loading); it weighs about 70 lbs. The case should also contain:
  • a.) The keypad;
  • b.) Black keypad cord that connects to the base unit;
  • c.) Yellow power cable that runs from the base unit to the cigarette lighter/12v power outlet on a vehicle;
  • d.) Propane hose that runs from the base unit to a propane tank;
  • e.) Small plastic pitcher and funnel for refilling the water extinguishers;
  • f.) Plastic sensor guard that fits over the face of the base unit.
• 2.) WATER fire extinguishers. Decide how many you will need based on how many trainees you expect. A single extinguisher is good for five or six passes.
• 3.) Tire inflator or portable air compressor, to charge the fire extinguishers to 100 PSI.
• 4.) Metal prop plate that goes over the base unit.
• 5.) Trash can prop, which fits over the metal prop plate.
• 6.) Small propane tank (the ones rented from 7-11 for grills work great).
• 7.) A dry-chem extinguisher to have on hand for safety.
• 8.) A vehicle or two to haul all this, and to provide power to the base unit. Everything can fit in one SUV or maybe a hatchback, or two standard sized sedans

System Set-up

1. Place the base unit in an open area away from all combustible materials. Ensure the front of the system is down wind (i.e. the wind is at the trainee's back).
2. Place the propane tank 10 ft. (3.0 m) behind the base unit.
3. Place the gas hose in a safe position (to prevent a tripping hazard).
4. Ensure the valve on the propane tank is completely closed.
5. Connect the quick disconnect end of the propane hose to the quick disconnect coupling on the rear of the base unit.

SmartExtinguisher Information

Only water extinguishers are appropriate for use with the portable burn pan. The best extinguishers to use are the SmartExtinguishers that came with the burn pan system. PBEM owns six of them (which will allow around 30 participants when they are appropriately filled and fully charged). Additional water extinguishers can be used if necessary. To use these extinguishers:

• Where possible, prepare the extinguishers the day before your exercise (it can take about 15 minutes to fully prep one).
• Unscrew the collar at the top of the extinguisher.
• Do not fill extinguishers to the top. Fill each one with six liters of water, replace the top, and hand tighten the collar.
• Connect an air compressor or tire inflator to the regulator on the extinguisher and pressurize to 100 PSI (6.9 bar) with compressed air.
• Stand about eight feet from the burn pan when discharging the extinguisher.

Filled and fully charged, these extinguishers can feel heavy. It is recommended that instructors choose trainees for the first discharges who are comfortable with the heavier weight.

Burn Pan Specifications

The burn pan is a Lion "Intelligent Training System (I.T.S.)" and accessories. The full kit includes:

Item	Lion Part #
I.T.S. Base unit	ITSBU01
7X SmartExtinguisher (qty. 6)	SE007XR
Handheld controller and controller cable	ITSC001
I.T.S. transport case	IC001
Base plate for props	ITSBP01
Trash can prop	PX01A

Only water extinguishers should EVER be used with the I.T.S.; dry-chem extinguishers will ruin the equipment^.

Burn Pan Program History

PBEM had access to a portable burn pan through one purchased with UASI funds and owned by regional partners. However, access was inconvenient and inconsistent. Recognizing the burn pan's value as an outreach tool, Jeremy at PBEM dedicated funds to purchase one for the bureau.

The portable burn pan was purchased in October 2019 with PBEM bureau general funds (i.e., it was not grant funded). The vendor was Tom Smith Fire Equipment Company, Inc. COVID-19 struck shortly after purchase and it was mothballed and placed in storage until its first use, during a Rosewood Initiative training event, on October 8 2022.