View source for Portable Burn Pan

PBEM's portable burn pan is a fire extinguisher demonstration tool intended primarily for community engagement events. However, it can also serve as a NET training tool for low-intensity training when the usual burn pan at Portland Fire & Rescue Training is not available. NET volunteers trained on its setup and use can check out the burn pan. 

You can read the full user manual from the manufacturer [[Media:LION Intelligent Training System Xtreme Manual.pdf|HERE.]]

You can read the user manual for the portable air pump [[Media:2024.02.15.Husky 12120V Inflator.pdf|HERE.]]
<br />

<span style="background:#FFFF00">'''As of July 2 2024, Portland is under a burn ban. We are unable to check out the burn pan during a burn ban. You can't burn as much as you can with a burn pan under a burn ban, man.'''<span><br />
__TOC__{{#ev:youtube|LVPF-XCqE3g|430|right|'''''Video: A comically dramatic preview of how the ITS works.'''''|frame}}
== Safety Considerations ==

=== Safety rules for scheduling burn pan check-out ===
* '''PBEM will check out the burn pan for use only on days when the heat index is BELOW 90°F.''' Not only is it unsafe for trainees to stand around in direct the sun for a prolonged period, but heat can cause the contents of a propane tank to expand and possibly cause a leak. If the borrower has a plan to mitigate these factors, PBEM can reconsider.
* '''A minimum of two volunteers trained on the burn pan is required to check it out for a session.''' One volunteer needs to operate the control pad, while the other needs to ensure trainees are engaging in safe practices and keeping an eye out for prospective hazards. One volunteer will also be challenged to load in and load out safely because the burn pan case is too heavy for most people to lift.
<br/>

=== Propane tank safety ===
{{#ev:youtube|uByGFFOyySY|430|right|'''''Video: Propane tank safety.'''''|frame}}
# [[File:Propane-tank-anatomy-expert-witness.jpg|alt=The guts of a propane tank.|thumb|''The insides of a propane tank.''|430x430px]]NEVER store or place a propane tank indoors or in an enclosed area such as a basement, garage, shed, or tent. It is illegal and highly unsafe to store propane tanks indoors.
# When transporting a propane tank in a vehicle:
#* ALWAYS make sure your vehicle is vented (e.g. open a window). 
#* Do not place a propane tank in a hot, confined space (such as a trunk on a hot day).
#* Make sure the propane tank is secure, preferably by placing it down and behind a seat. Think about where a 40 lb. propane tank is going to go if your vehicle were in a collision.
# NEVER try to modify or repair valves, regulators, or other tank parts.
# Operate the prop with a propane tank only when the tank is upright to ensure that only propane vapors are drawn from the tank.
<br/>

== Instructing with the Burn Pan ==
{{#ev:youtube|2HjonhsVD2E|430|right|'''''Video: It's important that people understand why you never use water on a grease fire.'''''|frame}}
The instructor MUST be familiar with, and able to instruct without deviating from, the CERT guidelines for CERT fire extinguisher use (click [https://hcpaw.portlandoregon.gov/u/raLYF0Qi2HG_otgU/d392e73d-a9f3-49bb-94eb-cd3449ada379?l HERE] to review). Optimally, trainees will also be familiar with this material.

Here are helpful videos to illustrate home fire dangers:

* [https://www.youtube.com/watch?v=2HjonhsVD2E '''What happens if you pour water into hot oil?:'''] Good showing on why you never use water to put out a stovetop fire (use baking soda instead).
* '''[https://youtu.be/BtMmymOxdjc Flashover Demonstration:]''' The Oak Ridge Fire Department shows you how fast a fire can grow.
* [https://youtu.be/l_y9_AfeuSs '''NIST Scotch Pine Demonstration:'''] Probably the most dramatic video; often shown in NET Basic.
* [https://www.youtube.com/watch?v=QqMVm72FMRk '''Room Flashover:'''] Demonstrates how quick fire can destroy a single room.
<br/>

== Burn Pan Set-up and Use ==

=== Burn pan ingredients ===
You will need:

* 1.) The burn pan base unit, which comes in a large plastic roll case. It requires two people to lift it safely as it weighs about 70 lbs. and is large. The case should contain:
** a.) The keypad;
** b.) Black keypad cord that connects to the base unit;
** c.) Yellow power cable that runs from the base unit to the cigarette lighter/12v power outlet on a vehicle;
** d.) Propane hose that runs from the base unit to a propane tank;
** e.) Small plastic pitcher and funnel for refilling the water extinguishers;
** f.) Plastic sensor guard that fits over the face of the base unit.
* 2.) '''WATER''' fire extinguishers. Decide how many you will need based on how many trainees you expect. A single extinguisher is good for five or six passes. PBEM owns six water extinguishers (which will allow around 30 participants when they are appropriately filled and fully charged). Additional water extinguishers can be used if necessary. 
* 3.) Tire inflator or portable air compressor, to charge the fire extinguishers to 100 PSI. PBEM has a tire inflator with the kit, but it's ''slow''. A volunteer who has access to a portable pancake air compressor is encouraged to bring it.
* 4.) Metal prop plate that goes over the base unit.
* 5.) Trash can prop, which fits over the metal prop plate.
* 6.) Small propane tank (the ones rented from 7-11 for grills work great).
* 7.) Two to two and a half gallons of water to fill the base unit.
* 8.) A dry-chem extinguisher to have on hand for safety, '''''not''''' for demonstration use.
* 9.) A vehicle or two to haul all this, and to provide power to the base unit. Everything can fit in one SUV or ''maybe'' a hatchback, or two standard sized sedans.
* 10.) A safe location. The prop should '''''NEVER''''' be used inside a building, garage, or enclosed area. Keep it 20 ft. away from vehicles, and do not use it near combustible materials. Set it up on a hard surface such as concrete, rock or stone (do not use on a wooden deck).
* 11.) Sufficient prep and break down time. You'll want 15 minutes for each extinguisher you need to prep, and 15 minutes to prep the base unit system. When the exercise is over, you'll need to wait ten minutes or so for the equipment to cool down and another five or ten to break it down.
<br/>

=== Transporting the props ===
Never leave this equipment unattended when not secure: not when transporting it, storing it, or using it. When transporting and storing it, all props must be kept in a secure location. Do not leave the props locked in an unattended car open to view (storing in the trunk is OK). The large case and shiny metal is an ideal target for thieves of even mediocre ability who can smash your window and pull it out of your vehicle in less than the time it took you to read this section.<br />

=== System set-up ===

# Place the base unit in an open area away from all combustible materials. Ensure the front of the system is down wind (i.e. the wind is at the trainee's back).
# Place the propane tank 10 ft. behind the base unit.
# Place the gas hose in a safe position (to prevent a tripping hazard).
# Ensure the valve on the propane tank is completely closed.
# Connect the quick disconnect end of the propane hose to the quick disconnect coupling on the rear of the base unit.
# Thread and tighten the propane fitting (regulator side) into the propane tank.
# Plug the male end of the black controller cable into the base unit.
# Plug the female end of the black controller cable into the handheld controller.
# Attach the yellow power cable to the rear of the base unit.
# Fill the burn pan with water to the side overflow cut-outs (roughly two gallons).
# Level the base unit using the adjustable feet.
# Remove the sensor guard.
# Confirm that a CO<small>2</small> or dry chem extinguisher is nearby and ready.
# Do a quick visual inspection for damage over the whole system.

=== System use ===
{| class="wikitable" border="1" style="float:right; width:25%"
| style="background:red; color:white; text-align: center" | '''<big>Safety Note</big>'''
|-
| style="padding:0px 0px 0px 10px;"| '''<big>Never attempt to manually light the pilot.</big>'''
|}
# Open the valve on the propane tank.
# Plug the male end of the yellow power cable into the 12V DC power receptacle.
# Enter the start sequence: '''FULL - IGNITION - A - IGNITION'''
# Set difficulty level and class of fire to desired conditions.
# Push and hold the '''HOLD TO RUN''' button. The main burners will ignite.
# Trainees should be instructed to start fighting the fire when the timer on the LCD screen starts counting.

=== Setting the difficulty ===

# [[File:Burnpan.jpg|alt=Diagram: the appropriate distances when instructing with the portable burn pan.|thumb|''Diagram: the appropriate distances when instructing with the portable burn pan. Click to enlarge.'']]Release all buttons on the handheld controller.
# Press and hold down the round FLARE UP button.
# After 3 seconds, the difficulty set menu will be displayed on the LCD screen.
# While continuing to hold down the round FLARE UP button, use the selector knob to change the difficulty level. There are four difficulty levels: 1, 2, 3, and 4, with 4 being the most difficult. On the selector knob, '''A''' corresponds to level 1, '''B''' corresponds to level 2, etc.
# Release the round FLARE UP button to lock in the difficulty level. The difficulty level is displayed on the LCD screen.

=== Setting the class of fire ===

# The class of fire can be set by moving the selector knob to either '''A''', '''B''', '''C''', or '''Full'''.
# The class of fire chosen will be displayed next to the difficulty setting.<br />

=== SmartExtinguisher information ===
Only water extinguishers are appropriate for use with the portable burn pan. The best extinguishers to use are the SmartExtinguishers that came with the burn pan system. To use these extinguishers:

* Where possible, prepare the extinguishers the day before your exercise (it can take about 15 minutes to fully prep one).
* Unscrew the collar at the top of the extinguisher.
* Do not fill extinguishers to the top. Fill each one with six liters of water, replace the top, and hand tighten the collar.
* Connect an air compressor or tire inflator to the regulator on the extinguisher and pressurize to 100 PSI (6.9 bar) with compressed air.
* Stand about eight feet from the burn pan when discharging the extinguisher. 

Filled and fully charged, these extinguishers can feel heavy. It is recommended that instructors choose trainees for the first discharges who are comfortable with the heavier weight.

=== Shut down operation ===
Do not attempt to pack up the unit until it has completely cooled.



== Burn Pan Specifications ==

The burn pan is a [https://www.lionprotects.com/fire-extinguisher-trainer-intelligent-training-system Lion "Intelligent Training System (I.T.S.)"] and accessories. The full kit includes:
{| class="wikitable"
|+
!Item
!Lion Part #
|-
|I.T.S. Base unit
|ITSBU01
|-
|7X SmartExtinguisher (qty. 6)
|SE007XR
|-
|Handheld controller and controller cable
|ITSC001
|-
|I.T.S. transport case
|IC001
|-
|Base plate for props
|ITSBP01
|-
|Trash can prop
|PX01A
|}
Only water extinguishers should '''''<u>EVER</u>''''' be used with the I.T.S.; dry-chem extinguishers will ruin the equipment<sup>.</sup>

== Burn Pan Program History ==
PBEM had access to a portable burn pan through one purchased with UASI funds and owned by regional partners. However, access was inconvenient and inconsistent. Recognizing the burn pan's value as an outreach tool, Jeremy at PBEM dedicated funds to purchase one for the bureau. 

The portable burn pan was purchased in October 2019 with PBEM bureau general funds (i.e., it was not grant funded). The vendor was [https://tsfequip.com/ Tom Smith Fire Equipment Company, Inc.] COVID-19 struck shortly after purchase and it was mothballed and placed in storage until its first use, during a Rosewood Initiative training event, on October 8 2022.