Subnet Control Operator Standard Operating Procedure: Difference between revisions
From Portland NET Wiki
BruceSchafer (talk | contribs) Removed obsolete senetence |
BruceSchafer (talk | contribs) Removed sentence. |
||
| Line 1: | Line 1: | ||
* Enable the Tactical Address for your region in Winlink Express. See [[Using Winlink Tactical Addresses#Enabling a Tactical Address|Enabling a Tactical Address]]. | * Enable the Tactical Address for your region in Winlink Express. See [[Using Winlink Tactical Addresses#Enabling a Tactical Address|Enabling a Tactical Address]]. | ||
* [[Check-in and Check-out Procedures#Checking into the Resource Net|Check into Resource Net]] on MC-2 Repeater (147.280 +600 KHz 167.9 Hz), which will typically use a directed check in for Subnet Control operators (SNCs). | * [[Check-in and Check-out Procedures#Checking into the Resource Net|Check into Resource Net]] on MC-2 Repeater (147.280 +600 KHz 167.9 Hz), which will typically use a directed check in for Subnet Control operators (SNCs). | ||
* Listen for an announcement of the regional frequencies to be used during the exercise. They may be different than shown in the frequencies in the table referenced above. Also note whether your region has been combined with another region for the exercise. If you previously detected a problem with the frequency that is assigned to your region, use the proword “Comment” and when recognized report the problem. Make note of any change of frequency that results. | * Listen for an announcement of the regional frequencies to be used during the exercise. They may be different than shown in the frequencies in the table referenced above. Also note whether your region has been combined with another region for the exercise. If you previously detected a problem with the frequency that is assigned to your region, use the proword “Comment” and when recognized report the problem. Make note of any change of frequency that results. | ||
